Verification Example 0021 | 4
Model to Download
Description
Verification Example 0021 | 4
Model Used in
Write Comment...
Write Comment...
Disclaimer
This structural analysis model available for download may be used for learning or testing purposes. There is no guarantee or liability for the accuracy or completeness of the model.
Separate Load Entry for Structure or Foundation Design
In RF-/FOUNDATION Pro, the foundation design requires the definition of the corresponding loading (load cases, load combinations, or result combinations) for different design situations (STR, GEO, UPL, or EQU).
New
Application of Connections to the Structure | Steel Joints
- The proposed connection can be applied to all selected nodes in the structure
- The location of the connection can be defined using the "Main" tab of the Add-on dialog box
- The design is performed for all connections in the structure and after the calculation, the results on all connections can be displayed
- The table shows the results for the individual connections, each connection is designed and can be saved separately
- I do not want to design a cross-section in the RF‑/STEEL EC3 add-on module. Can I quickly remove this cross-section from the selection?
- Are the models and presentations from Info Day 2018 freely available, and can you send them to me?
- I am designing a set of members using the equivalent member method in RF‑/STEEL EC3, but the calculation fails. The system is unstable, delivering the message "Non-designable - ER055) Zero value of the critical moment on the segment".What could be the reason?
- How can I display the internal forces in the global coordinate system and not in the principal coordinate system of the cross-section?
- I want to create a mapped mesh for a circular hole plate. Is it possible to generate such a mesh in RFEM?
- I have a trapezoidal roof structure supported by beams. However, the moments on the beams are smaller than they should be. What could be the reason for this?
- Is it possible to divide a free surface load by the existing lines in RFEM?
- I am designing a cross-section created in the SHAPE‑THIN program using the design add-on module, but the program shows the error message "ER006 Invalid type of c/t-part for cross-section of type General". What can I do?
- How do I display some results of all load cases in the printout report, but other results of selected load cases only?
- Why are some load cases displayed in red in RF‑STEEL EC3?
