Check out these tips to help you get started with the RFEM program.
Webinar | Introduction to the New RFEM 6
Video
First Steps with RFEM
Description
This webinar provides an introduction to the new generation FEA software RFEM 6.
Time Schedule:
00:00 Introduction
09:20 Steel and concrete member and surface modeling
26:55 Load cases, combinations, and load application
42:10 Steel and concrete design add-on input data
49:58 Calculation and analysis results review
52:37 Steel and concrete design add-on results review
57:50 New printout report options
1:04:55 Conclusion
Keywords
Free webinar New features Printout report Multi-core Integrated add-ons FEA
Links
Write Comment...
Write Comment...
Contact Us
Do you have any questions about our products or which are best suited for your design projects? Contact us via phone, email, or chat or find suggested solutions and useful tips on our FAQ page available 24/7.

New
Modal Analysis in RFEM 6 Using a Practical Example
Modal analysis is the starting point for the dynamic analysis of structural systems. This article shows you a summary of how to perform a modal analysis in RFEM 6.

New
Application of Connections to the Structure | Steel Joints
- The proposed connection can be applied to all selected nodes in the structure
- The location of the connection can be defined using the "Main" tab of the Add-on dialog box
- The design is performed for all connections in the structure and after the calculation, the results on all connections can be displayed
- The table shows the results for the individual connections, each connection is designed and can be saved separately
-
How do I set a release for warping?
- How can I define a warping spring or a warping restraint?
- At which point on a cross-section are the supports and loads assumed for the calculation with warping torsion?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- How can I deactivate the 7th degree of freedom for certain members or cross-sections only?
- How can I define a warping spring or a warping restraint?