Check out these tips to help you get started with the RFEM program.
Webinar | AISC 360-16 Steel Design in RFEM 6
Video
First Steps with RFEM
Description
This recorded webinar provides an introduction to steel design acc. to the AISC 360-16 in RFEM 6.
Time Schedule:
00:00 Introduction
01:40 Steel structure modeling in RFEM
22:10 Load case definition and load application
31:10 AISC 360-16 Ch. C Direct Analysis Method considerations
48:38 Steel Design Add-on model input data
59:21 Review of analysis and design results
1:04:40 Conclusion
Keywords
Free webinar Steel AISC AISC 360 AISC 360-16 Direct analysis method
Links
Write Comment...
Write Comment...
Contact Us
Do you have any questions about our products or which are best suited for your design projects? Contact us via phone, email, or chat or find suggested solutions and useful tips on our FAQ page available 24/7.

New
Evaluating and Documenting Steel Joints Analysis Results in RFEM 6
With the RFEM 6 add-on Steel Joints, you can analyze steel connections by using an FE model. This article demonstrates how to evaluate and document the steel joints analysis results.

New
Application of Connections to the Structure | Steel Joints
- The proposed connection can be applied to all selected nodes in the structure
- The location of the connection can be defined using the "Main" tab of the Add-on dialog box
- The design is performed for all connections in the structure and after the calculation, the results on all connections can be displayed
- The table shows the results for the individual connections, each connection is designed and can be saved separately
-
How do I set a release for warping?
- How can I define a warping spring or a warping restraint?
- At which point on a cross-section are the supports and loads assumed for the calculation with warping torsion?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- How can I deactivate the 7th degree of freedom for certain members or cross-sections only?
- How can I define a warping spring or a warping restraint?