Check out these tips to help you get started with the RFEM program.
Webinar | ACI 318-19 Concrete Design in RFEM 6
Video
First Steps with RFEM
Description
This recorded webinar provides an introduction to concrete design acc. to the ACI 318-19 in RFEM 6.
Time Schedule:
00:00 Introduction
01:40 Example 1 - concrete beam modeling and loading
15:00 LRFD Design Situation analysis results
16:20 Beam reinforcement input data
27:50 ACI 318-19 design results review
32:10 Example 2 - concrete surface and member reinforcement input data
52:33 ACI 318-19 design results review
57:40 Printout report options
1:03:31 Conclusion
Keywords
Free webinar Concrete Reinforced concrete ACI 318 ACI 318-19
Links
Write Comment...
Write Comment...
Contact Us
Do you have any questions about our products or which are best suited for your design projects? Contact us via phone, email, or chat or find suggested solutions and useful tips on our FAQ page available 24/7.
New
Modal Analysis in RFEM 6 Using a Practical Example
Modal analysis is the starting point for the dynamic analysis of structural systems. This article shows you a summary of how to perform a modal analysis in RFEM 6.
New
Concrete Design | Reinforced Concrete Design with Net Concrete Area
During the cross-section design, you can control whether the concrete surface is applied behind the reinforcing bars or is subtracted from the concrete cross-section. The design of the net concrete cross-section is mainly used for highly reinforced cross-sections.-
The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?
- How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
- Where can I find the graphical results of punching shear in the concrete design? Especially the distribution of shear forces at the critical perimeter or the punching loads.
- Is it possible to display the reinforcement description in RFEM 6?
-
I would like to export nodal support forces of several load cases, load combinations and result combinations into an Excel spreadsheet in RFEM 6. How should I proceed?
- Where can find the option to hide the defined types (for example, design supports or effective lengths)?
- How do I create a user-defined Design Situation with my own chosen load combinations?
- Can I define a different bar size in the RFEM 6 Concrete Design add-on other than the default bar sizes available in the drop-down?
- Can the RFEM 6 Concrete Design add-on automatically design member and surface reinforcement?
Social Networks
Frequently Visited Pages
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?
