Modeling of Timber-Concrete Composite Floor
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
The cross-section resistance design analyzes tension and compression along the grain, bending, bending and tension/compression as well as the strength in shear due to shear force.
The design of structural components at risk of buckling or lateral-torsional buckling is performed according to the Equivalent Member Method and considers the systematic axial compression, bending with and without compressive force as well as bending and tension. Deflection of inner spans and cantilevers is compared to the maximal allowable deflection.
Separate design cases allow for a flexible and stability analysis of members, sets of members, and loads.
Design-relevant parameters such as the stability analysis type, member slendernesses, and limit deflections can be freely adjusted.
- Are the models and presentations from Info Day 2020 freely available, and can you send them to me?
- Is it possible to open the RX‑TIMBER files in RFEM and RSTAB?
- Can I use RFEM to calculate a log house three-dimensionally?
- How do I display some results of all load cases in the printout report, but other results of the selected load cases only?
- Can I design laminated veneer lumber with RFEM/RSTAB?
- I would like to carry out the flexural buckling design for timber components with imperfections and internal forces according to the second-order analysis. Is it sufficient to activate this in Details of the RF‑/TIMBER Pro add-on module or is it necessary to make additional settings?
- How can I calculate a timber-concrete composite floor with cross-laminated timber?
Cum sociis natoque penatibus et magnis dis parturient montes, nascetur ridiculus mus. Pellentesque arcu. Nulla pulvinar eleifend sem. Fusce consectetuer risus a nunc.
- Is it possible to save the structures of the manufacturer-specific cross-laminated timber plates in the RF‑LAMINATE add-on module?
- How is it possible to display the main support direction graphically in RF‑LAMINATE?
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements
The structural engineering software for design of frame, beam and truss structures, performing linear and nonlinear calculations of internal forces, deformations, and support reactions