This structural analysis model available for download may be used for learning or testing purposes. There is no guarantee or liability for the accuracy or completeness of the model.
Isolated Square Footing
Model to Download
Description
Isolated concrete square footing, reinforcement calculation according to ACI318-14.
Model created by the Dlubal Latam engineering team. The model is also available as a parameterized block on the Dlubal Latam website.
Keywords
Concrete Reinforcement Square Footing Shaft Flat
Write Comment...
Write Comment...
- Views 19x
- Downloads 2x
- Updated 09/20/2023
- Block parameters editable dynamically
- Number of Nodes 27
- Number of Lines 33
- Number of Members 1
- Number of Surfaces 17
- Number of Solids 3
- Number of Load Cases 3
- Number of Load Combinations 4
- Number of Result Combinations 2
- Total Weight 11.632 tons
- Dimensions 8.44 x 8.44 x 11.15 feet
- Program Version 5.18.01
Disclaimer
Design of Concrete Columns Subjected to Axial Compression with RF-CONCRETE Columns
This article compares the design to the one in the referenced article: Design of Concrete Columns Subjected to Axial Compression with RF-CONCRETE Members. It is, therefore, about taking exactly the same theoretical application carried out in RF-CONCRETE Members and reproducing it in RF-CONCRETE Columns. Thus, the objective is to compare the different input parameters and the results obtained by the two add-on modules for the design of column-like concrete members.
- What is the maximum number of reinforcement groups that can be created in a design case in RF‑CONCRETE Surfaces?
- I have a roof structure resting on a steel column that runs to the foundations. The column runs through a perimeter wall that supports the false ceiling. A considerable part of the load from the roof is transferred to the wall. I want the steel column to carry all the vertical loads from the roof. How can I do it?
- Are the models and presentations from Info Day 2018 freely available, and can you send them to me?
-
I have installed Halfen HDB 13.60 on my PC. The version does not seem to be compatible with RF‑PUNCH Pro anymore. The interface does not work. I am using version 5.26.02 of RFEM.
- When designing a foundation slab under a circular tank, the contact stress in the middle of the surface is not displayed. What could be the reason?
