Check out these tips to help you get started with the RFEM program.
Webinar | ADM 2020 Member Design in RFEM
Video
First Steps with RFEM
Description
This webinar demonstrates the aluminum member design workflow according to the Aluminum Design Manual (ADM) 2020 in RFEM.
Time Schedule:
00:00 Introduction
02:47 Custom extruded section in SHAPE-THIN
08:47 Aluminum member modeling in RFEM
22:55 Fabric tensile surfaces and cables with RF-FORM-FINDING
28:30 Load definitions including RWIND Simulation
38:15 Analysis results in RFEM
42:45 Aluminum member design acc. to ADM 2020 with RF-ALUMINUM ADM
1:01:27 Conclusion
Keywords
Aluminum ADM ADM 2020 Fabric tensile Form-finding CFD Wind Local buckling Extruded section
Write Comment...
Write Comment...
Contact Us
Do you have any questions about our products or which are best suited for your design projects? Contact us via phone, email, chat, or forum, or search the FAQ page, available 24/7.
Aluminum Design | Tension Design Considering Reduced Cross-Sectional Area (such as Hole Weakening)
When connecting tension-loaded components with bolted connections, it is absolutely necessary to consider the cross-section reduction due to the bolt holes in the ultimate limit state design. The Aluminum Design add-on facilitates this procedure by entering a member local section reduction.
Aluminum Design | Consideration of Internal Forces from Calculation with Torsional Warping (7 Degrees of Freedom)
Aluminum Design | Design Checks for General RSECTION Cross-Sections
Aluminum Design | Graphical Display of Mode Shape for Lateral-Torsional Buckling Analysis
Aluminum Design | Strength and Stability | Input
