Check out these tips to help you get started with the RFEM program.
Stress Analysis of Surfaces and Members in RFEM 6 and RSTAB 9
Video
First Steps with RFEM
Description
In this free webinar, we show you the options you have in RFEM 6 and RSTAB 9 for modeling and designing solids and welds, calculating stress ranges for fatigue design and creating documentation.
Time Schedule:
00:00 Introduction
05:10 Modeling and design of members, surfaces, and solids
30:35 Modeling and design of welds
53:30 Calculation of stress ranges for fatigue design
61:40 Result evaluation and documentation
Keywords
Dlubal Webinar Free webinar RFEM 6 RSTAB 9 Stress analysis Solid Fatigue design Results evaluation Documentation Webinar on Dlubal Software Webinar Dlubal Tutorial Construction industry Civil engineering Structural engineer Structural Design structural engineer Structural analysis Structural Engineer Dlubal Software
Downloads
- Presentation Slides to Webinar "Stress Analysis of Surfaces and Members in RFEM 6 and RSTAB 9" (PDF)
Links
Write Comment...
Write Comment...
Contact Us
Do you have any questions about our products or which are best suited for your design projects? Contact us via phone, email, or chat or find suggested solutions and useful tips on our FAQ page available 24/7.

New
Local Buckling of Flexural Members per ADM 2020 in RFEM 6
This article discusses the options available for determining the nominal flexural strength, Mnlb for the limit state of local buckling when designing according to the 2020 Aluminum Design Manual.
-
How can I carry out case-related design for different load situations?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
- How do I create a user-defined Design Situation with my own chosen load combinations?
- Where can I find the materials for the corresponding National Annexes in RFEM 6 and RSTAB 9?
- How do I apply wind load on members of open structures?
- I encountered a sharing violation while importing a dxf file into SHAPE‑THIN. What is the issue?
- How is the automatic creation of c/t-parts carried out?
- I want to create a mapped mesh for a circular hole plate. Is it possible to generate such a mesh in RFEM?
- Is it possible to consider the reduction of strength in the heat affected zone (HAZ) in the RF‑/ALUMINUM add-on module?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?