In RFEM, I have split a member in surfaces. How should I change the previously applied member load to affect the surface after splitting the member in surfaces?
If a member is separated into surfaces, member loads cannot be used anymore. In this case, the easiest way is to create a line on the load introduction point and put a line load on it. You can simply copy the member load parameter from input tables and paste it in the table of line load.
Staff load, Distributed load, Rod disassemble into surfaces
Have you found your question?
If not, contact us or send us your question via the online form.
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements