New
FAQ 002601 EN-US 03/06/2019

Wieland Götzler Add-on Modules STEEL Plasticity RF-STEEL Plasticity

What causes the checkbox "Use selected method also for the calculation of all supported cross sections" in STAHL Plasticity?

Answer

For example, the checkbox activates the use of the simplex method also for I-profiles,
which otherwise automatically with the partial section size method incl. Rearrangement be measured. If the checkbox is deactivated, the Simplex Method or the partial section size method, depending on the choice, is only used if a general cross section (for example from DuenQ) is to be dimensioned.

Keywords

Plastic Steel construction Steel design Eurocode 3 EC3 TSV Partial section size method Simplex Load capacity General cross section Plasticity

Contact us

Contact Dlubal Software

Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.

(267) 702-2815

info-us@dlubal.com

RSTAB Steel and Aluminum Structures
STEEL Plasticity 8.xx

Module Extension for STEEL EC3

Plastic design of cross-sections according the Partial Internal Forces Method (PIFM) and Simplex Method

Price of First License
850.00 USD
RFEM Steel and Aluminum Structures
RF-STEEL Plasticity 5.xx

Module Extension for RF-STEEL EC3

Plastic design of cross-sections according the Partial Internal Forces Method (PIFM) and Simplex Method

Price of First License
850.00 USD