Settings - Decimal Places

Helpful Questions & Answers

  • Frequently Asked Questions (FAQs)

How can I adjust the number of decimal places in the standardized table values of a mode shape?

Answer

In RFEM and all add-on modules, the units and decimal places are managed in one dialog box.
To adjust this, open Units and Decimal Places under Options.


You can modify the settings as you need during the modeling or evaluation. All numerical values are converted or adjusted.

Keywords

Decimal place Decimal place Mode shape

Links

Write Comment...

Write Comment...

  • Views 154x
  • Updated 10/27/2021

Contact Us

Contact Dlubal

Can’t find the answer to your question? Contact us via phone, email, chat, or forum or send us your question directly through our online form.

Submit Individual Question

(267) 702-2815

info-us@dlubal.com

Online Training | English

RFEM 6 | Dynamic Analysis and Seismic Design According to EC 8

Online Training 03/10/2022 8:30 AM - 12:30 PM CET

Blast Time History Analysis in RFEM

Blast Time History Analysis in RFEM

Webinar 05/13/2021 2:00 PM - 3:00 PM EST

NBC 2015 Modal Response Spectrum Analysis in RFEM

NBC 2015 Modal Response Spectrum Analysis in RFEM

Webinar 09/30/2020 2:00 PM - 3:00 PM EST

ASCE 7-16 Response Spectrum Analysis in RFEM

ASCE 7-16 Response Spectrum Analysis in RFEM

Webinar 05/22/2019 3:00 PM - 4:00 PM

Nonlinear Time History Analysis in RFEM

Nonlinear Time History Analysis in RFEM

Webinar 05/08/2018 3:00 PM - 4:00 PM EST

Time-History Analysis in RFEM - Induced Vibrations

Time-History Analysis in RFEM - Induced Vibrations

Webinar 01/26/2017 3:00 PM - 4:00 PM

Multi-Story Concrete and Steel Structure Modeled in RFEM

RFEM 5 - Introduction into Dlubal Software (USA)

Webinar 02/09/2016 3:00 PM - 4:00 PM