Scaffolding Release Dependent on Normal Force
Tips & Tricks
In RFEM, it is possible to simulate a scaffolding tube joint (butt joint with a stub) by a nonlinear member release of the “Scaffolding” type. The joint considers moment resistance dependent on compression forces existing between two outer tubes and the stub also has certain moment resistance based on its bending resistance.
The outer tube pair is described in the release definition by the M-N interaction diagram.
The bending resistance of the inner tube stub is defined by the M-φ diagram.
The axial load bearing capacity of the connection depends on the interaction diagram of outer tubes and determined by the N-ux diagram.
If the moment load of the connection rests
- within the interaction curve in the normal force interval described, the outer tubes transfer the bending moment and the connection reacts rigidly,
- above the interaction curve in the normal force interval described, the outer tubes transfer the moment part dependent on the normal force and with regard to the diagram, the stub transfers the rest until the yield moment is reached,
- next to the interaction curve outside the normal force interval described, the outer tubes transfer the normal force dependent on the moment and changes over to yielding.
Do you have any questions or need advice?
Contact us or find various suggested solutions and useful tips on our FAQ page.
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements