Tent Roof with Two Cone Tips
Model to Download
-
01
Tent Roof with Two Cone Tips
-
01
Tent Roof with Two Cone Tips, Deformation
-
01
Tent Roof with Two Cone Tips, Z-Axis Direction View
-
01
Tent Roof with Two Cone Tips, Z-Axis Direction View, Deformation
-
01
Tent Roof with Two Cone Tips, X-Axis Direction View
-
01
Tent Roof with Two Cone Tips, X-Axis Direction View, Deformation
-
01
Tent Roof with Two Cone Tips, Y-Axis Direction View
-
01
Tent Roof with Two Cone Tips, Y-Axis Direction View, Deformation
Disclaimer
New
Not all structural elements of a real building are included in a structural model. As an example, we can look at a pipe that runs along a steel girder frame.
SHAPE-THIN determines the effective cross-sections according to EN 1993-1-3 and EN 1993-1-5 for cold-formed sections. You can optionally check the geometric conditions for the applicability of the standard specified in EN 1993‑1‑3, Section 5.2.
The effects of local plate buckling are considered according to the method of reduced widths and the possible buckling of stiffeners (instability) is considered for stiffened sections according to EN 1993-1-3, Section 5.5.
As an option, you can perform an iterative calculation to optimize the effective cross-section.
You can display the effective cross-sections graphically.
Read more about designing cold-formed sections with SHAPE-THIN and RF-/STEEL Cold-Formed Sections in this technical article: Design of a Thin-Walled, Cold-Formed C-Section According to EN 1993-1-3.
- How do I model a tent roof with two cone tips?
-
Can I export my cutting pattern?
- I am trying to manually check the deformations from the CRANEWAY add-on module. However, I obtain great deviations. How to explain the differences?
- What should be considered when using a failure of columns under tension in the RF‑/DYNAM Pro – Equivalent Loads add-on module?
- Why is there no stability analysis displayed in the results despite the activation of the stability analysis in RF‑/STEEL EC3?
- How can I model and design a crane runway girder with Dlubal Software?
- How do I model a suspended membrane roof structure with line supports?
- Is it possible to set user-defined values when viewing solid stress results?
- Why do I get large differences for the design of a longitudinally stiffened buckling panel in comparison with the German and Austrian National Annex?
- How are the signs for the release results of a line release and line hinges interpreted?
