We provide hints and tips to help you get started with the basic program RFEM.
KB 000924 | Adjusting Reinforcement Drawings
Video
First Steps with RFEM
Description
In RF-/FOUNDATION Pro, reinforcement drawings are displayed after designing the foundation, where you can record all necessary structures of the reinforcement steel.
Keywords
Dlubal Knowledge Base Foundation Reinforcement drawing Reinforcement Plan mandrel diameter Tangential Axial Dimensions Dlubal KB Knowledge Base Technical Contribution
Links
Write Comment...
Write Comment...
Contact us
Do you have any questions about our products or need advice on selecting the products needed for your projects?
Contact us via our free e-mail, chat, or forum support or find various suggested solutions and useful tips on our FAQ page.
New
Adjusting Reinforcement Drawings
In RF-/FOUNDATION Pro, reinforcement drawings are displayed after designing the foundation, where you can record all necessary structures of the reinforcement steel.
Material Model Orthotropic Masonry 2D
The material model Orthotropic Masonry 2D is an elastoplastic model that additionally allows softening of the material, which can be different in the local x- and y-direction of a surface. The material model is suitable for (unreinforced) masonry walls with in-plane loads.
- Does the program check the lap length of the vertical stirrups of a block foundation with smooth bucket sides?
- How is the static depth d calculated in the bending design of block foundations (calculation as equivalent beams)?
- Is it also possible to perform the crack width analysis according to EN 1992‑1‑1, Section 7.3, in RF‑/FOUNDATION Pro?
- Where on the foundation is the load applied in the design with FOUNDATION Pro?
- How can I enter the earth covering of a bucket foundation up to 10 cm below the top edge of the bucket in RF‑/FOUNDATION Pro?
- Which principles are used for the design of the lap length performed in RF‑/FOUNDATION Pro? And can I deactivate this design?
- Which theoretical approaches are used in RF‑/FOUNDATION Pro for pocket foundations with rough bucket sides to divide the forces and moments and carry out the reinforcement layout?
- Can I only apply an impact load to the bucket instead of the entire foundation?
- Is it possible to reinforce a foundation with a pure reinforcing bar?
- I have to perform a recalculation of a foundation in the existing structure and looking for design according to DIN 1045 or DIN 1054 for this. In RF‑/FOUNDATION Pro, there is only the Eurocode available to me. Do you have any other module for the foundation design?
