This webinar shows you the questions asked about RFEM 6 and RSTAB 9, which have recently been answered by Dlubal support team.
Time Schedule:
00:00 Introduction
02:35 When I start the steel design in the serviceability limit state, I get an error message that the member sets have incompatible local systems of internal members. What does that mean and what should I do?
08:15 How can I set user-defined points for evaluating results on surfaces?
11:20 Can I increase the loading gradually in RFEM 6?
18:25 According to Eurocode 2, I can reduce the support moment of a continuous beam. How do I consider this in RFEM 6?
25:00 I have defined an additional reinforcement on a punching node. However, it is not considered in the punching shear design. What is the reason?
31:35 In a multi-surface system, I use line releases to achieve lifting of the surfaces from a grillage. Unfortunately, the surfaces get 'stuck' in single locations. How can I avoid this?