28 Results
View results:
Sort by:
Question
I want to create a mapped mesh for a circular hole plate. Is it possible to generate such a mesh in RFEM?
Question
How can I optimize the calculation time in CRANEWAY?
Question
How do I create a frame joint with taper in JOINTS Steel - Rigid?
Question
How can I create a drilled beam in RFEM?
Question
How can I additionally model welds for the connection of two surfaces with a contact solid?
Question
In connection with a calculation according to the large deformation analysis, I get significantly smaller deformations than for a calculation according to the linear static or second-order analysis. How is this possible?
Question
I get a message saying that the General Method is only allowed for I-sections, even though I do want to design an I-section. Why?
Question
I have calculated a box girder. Which surface results or surface stresses can I use to evaluate the buckling behavior of the web plates?
Question
When entering data in the RF‑/STEEL EC3 add-on module, I get the error message "Incorrect location of the intermediate lateral restraint". Why?
Question
When creating a material, there are no nonlinear material models available for surfaces or solids. Why?
Desing in Industrial and Plant Engineering
Are Dlubal Software programs applicable for the analysis of process manufacturing plants?
Question
How can I deduce the axial stress and hoop stress of a circular container?
Question
How can I connect surfaces to other surfaces or members in a hinged/semi-rigid way?
Design of Piping Systems
Is it possible to analyze and design piping systems with Dlubal Software?
- 004165
- RFEM 5
- RSTAB 8
-
- Power Plants
- Steel Structures
- Process Manufacturing Plants
- Bridges
- Towers and Masts
- Temporary Structures
- Scaffolding and Rack Structures
- Offshore Structures
- Silos and Storage Tanks
- Buildings
- Piping Systems
- Cranes and Craneways
- Renewable Energy Structures
- Conveyor Structures
- Drilling Structures
- Stairway Structures
- Wind Simulation & Wind Load Generation
Question
How is it possible to consider the real cross-section geometry of member elements in RWIND Simulation?
Question
Is it also possible to simulate an external steel structure in RWIND Simulation?
Question
Is it possible to design a "Kármán vortex street" behind an object in the numerical wind tunnel of RWIND Simulation?
Question
I designed a steel connection using RF‑JOINTS, then created a model to compare it in RFEM. Why are the results not identical?
Question
Does the fatigue design in CRANEWAY also consider welded stiffeners?
Question
Why do I obtain different results for the same end plate joint in RF‑/JOINTS Steel - DSTV and RF‑/JOINTS Steel - Rigid?
Question
When calculating a connection using the FRAME‑JOINT Pro add-on module, a message appears saying that the value is out of the valid range (existing value: 160, minimum value 200). What does this message mean?
Question
Why are the stiffness modifications not taken into account when determining critical load factors in the RF‑STABILITY add-on module?
Question
Why are the tolerance zones between the zone borders 5 km wide on the online snow load map of Austria?
- 002913
- RF-DYNAM Pro | Natural Vibrations 5
- RF-DYNAM Pro | Equivalent Loads 5
-
- RF-DYNAM Pro | Forced Vibrations 5
- RF-DYNAM Pro | Nonlinear Time History 5
- DYNAM Pro | Natural Vibrations 8
- DYNAM Pro | Equivalent Loads 8
- DYNAM Pro | Nonlinear Time History 8
- Concrete Structures
- Steel Structures
- Timber Structures
- Mechanical Engineering
- Process Manufacturing Plants
- Bridges
- Dynamic and Seismic Analysis
- Nonlinear Dynamics