19 Results
View results:
Sort by:
Consideration of Heat Affected Zone for Aluminum
Is it possible to consider the reduction of strength in the heat affected zone (HAZ) in the RF‑/ALUMINUM add-on module?
Question
I am trying to design an open, unsymmetric aluminum cross-section in RF‑/ALUMINUM and I am get the warning "Non-designable - 1022) General cross-section — Check of stability is not available". What is the reason?
Effective Length Factors for Aluminum and Steel Design
Are effective length factors determined automatically from a model in the add-on modules for aluminum and steel design, or do I have to make adjustments?
Question
I have performed a buckling analysis in RF‑ALUMINUM. Where can I find the parameters used for the design in the add-on module?
Question
It is not possible to design a SHAPE‑THIN cross-section due to invalid symmetry. What is the cause and how can I fix it?
Question
I need to define different types of lateral intermediate restrains for a single element in RF-/STEEL EC3. Is this possible?
Question
The calculation of a result combination in STEEL EC3 or ALUMINUM takes a very long time. What might be the cause, and how can I improve the performance?
Question
Is there a way to prepare an EC3 buckling check without setting the intermediate support manually, or is there a workaround that can speed this up?
Question
Which modules can be accessed via the COM interfaces RS‑COM and RF‑COM?
Question
I get an implausible result with the expression "1.#J" in the RF‑/ALUMINUM add-on module.
How can I fix this?
- 003312
- CONCRETE 8
- ALUMINUM 8
-
- CONCRETE Columns 8
- EC2 for RFEM 5
- EC2 for RSTAB 8
- TIMBER Pro 8
- CRANEWAY 8
- RF-CONCRETE Columns 5
- RF-CONCRETE 5
- RF-PLATE-BUCKLING 5
- RF-FOUNDATION Pro 5
- RF-HSS 5
- RF-GLASS 5
- RF-TIMBER Pro 5
- RF-SOILIN 5
- RF-FRAME-JOINT Pro 5
- RF-STEEL EC3 5
- RF-PUNCH Pro 5
- Eurocode 2
- Eurocode 3
- Eurocode 5
- Eurocode 9
- Eurocode 7
Question
How can I change the Standard / National Annex set for the design in the add-on modules and stand-alone programs?
Question
Why does my calculation in the RF‑/ALUMINUM add‑on module take so long?
Question
How can I change the allowable thickness ranges for the material in RF‑/ALUMINUM or RF‑/STEEL EC3?
Question
Why is it not possible to select sets of members for the serviceability limit state design in the respective design modules? I cannot specify sets of members under "Serviceability Data".
Question
The printout report of the STEEL EC3 results is too long. How can I reduce the content to a minimum?
- 002628
- ALUMINUM 8
- ALUMINUM ADM 8
-
- RF-ALUMINUM 5
- RF-ALUMINUM ADM 5
- RF-STEEL 5
- RF-STEEL AISC 5
- RF-STEEL AS 5
- RF-STEEL BS 5
- RF-STEEL CSA 5
- RF-STEEL EC3 5
- RF-STEEL Fatigue Members 5
- RF-STEEL NTC-DF 5
- RF-STEEL SIA 5
- STEEL 8
- STEEL AISC 8
- STEEL AS 8
- STEEL BS 8
- STEEL CSA 8
- STEEL EC3 8
- STEEL Fatigue Members 8
- STEEL SIA 8
- KAPPA 8
- RF-KAPPA 5
- LTB 8
- RF-LTB 5
- Steel Structures
- Stress Analysis
- Stability Analysis