4 Results
View results:
Sort by:
Question
I am designing a cross-section created in the SHAPE‑THIN program using the design add-on module, but the program shows the error message "ER006 Invalid type of c/t-part for cross-section of type General". What can I do?
Question
I need to define different types of lateral intermediate restrains for a single element in RF-/STEEL EC3. Is this possible?
- 002546
- RF-STEEL 5
- STEEL 8
-
- RF-STEEL AISC 5
- RF-STEEL AS 5
- RF-STEEL BS 5
- RF-STEEL CSA 5
- RF-STEEL EC3 5
- RF-STEEL Fatigue Members 5
- RF-STEEL GB 5
- RF-STEEL HK 5
- RF-STEEL IS 5
- RF-STEEL NBR 5
- RF-STEEL NTC-DF 5
- RF-STEEL Plasticity 5
- RF-STEEL Plasticity 5
- RF-STEEL SANS 5
- RF-STEEL SIA 5
- RF-STEEL SP 5
- RF-STEEL Warping Torsion 5
- STEEL AISC 8
- STEEL AS 8
- STEEL BS 8
- STEEL CSA 8
- STEEL EC3 8
- STEEL Fatigue Members 8
- STEEL GB 8
- STEEL HK 8
- STEEL IS 8
- STEEL NBR 8
- STEEL NTC-DF 8
- STEEL Plasticity 8
- STEEL Plasticity 8
- STEEL SANS 8
- STEEL SIA 8
- STEEL SP 8
- STEEL Warping Torsion 8
- RF-TIMBER AWC 5
- RF-TIMBER CSA 5
- RF-TIMBER NBR 5
- RF-TIMBER Pro 5
- RF-ALUMINUM 5
- RF-ALUMINUM ADM 5
- TIMBER AWC 8
- TIMBER CSA 8
- TIMBER NBR 8
- TIMBER Pro 8
Question
I have modified cross-section properties or reduced stiffnesses of a member in RFEM/RSTAB. After a new calculation, the deformation of the structural system has adjusted itself to the new cross-section properties. However, this change is not taken into account when performing design in add-on modules.
- 002628
- ALUMINUM 8
- ALUMINUM ADM 8
-
- RF-ALUMINUM 5
- RF-ALUMINUM ADM 5
- RF-STEEL 5
- RF-STEEL AISC 5
- RF-STEEL AS 5
- RF-STEEL BS 5
- RF-STEEL CSA 5
- RF-STEEL EC3 5
- RF-STEEL Fatigue Members 5
- RF-STEEL NTC-DF 5
- RF-STEEL SIA 5
- STEEL 8
- STEEL AISC 8
- STEEL AS 8
- STEEL BS 8
- STEEL CSA 8
- STEEL EC3 8
- STEEL Fatigue Members 8
- STEEL SIA 8
- KAPPA 8
- RF-KAPPA 5
- LTB 8
- RF-LTB 5
- Steel Structures
- Stress Analysis
- Stability Analysis