Punching Shear Design in Foundation Slabs
Product Feature
For structural components consisting of slabs, it is necessary to perform shear design on the locations with the concentrated load introduction, applying the punching shear design rules according to 6.4, EN 1992‑1‑1. In addition to floor slabs, it is also possible to subsequently design foundation slabs.
The punching design parameters for the selected nodes can be defined in the Ultimate Configuration for concrete design.
Write Comment...
Write Comment...
New
Consideration of Shear Stiffness for a Cross-Section Calculation in RFEM 6
This article shows you the internal forces and displacements of a continuous beam calculated both with and without consideration of shear stiffness.
-
Why the eHORA map of Austria gives different snow loads than your Geo-Zone tool?
- Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?
- How can I consider various wind profiles for various wind directions?
- How can I carry out case-related design for different load situations?
- How can I check the way RFEM 6 determines the required reinforcement?
-
Although all the member design checks have been fulfilled, I get the "Not Covered Reinforcement" result. What is the reason?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
Associated Products
RFEM 6
Design
In the Concrete Design add-on, various designs according to international standards are possible. You can design members, surfaces, and columns, as well as perform punching and deformation analyses.
Price of First License
2,200.00 USDRSTAB 9
Design
In the Concrete Design add-on, various designs according to international standards are possible. You can design members and columns.
Price of First License
2,200.00 USD
Social Networks
Frequently Visited Pages
- Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?
