Model to Download
This model was used to demonstrate the creation and display of a temporary calculation model.
Model Used in
When using the RF‑GLASS add‑on module, you can define in the main program just the geometry as well as the load situation of the structural component to be designed. The respective support conditions and all further design-relevant definitions, for example the layer structure and support conditions, can be further specified in RF‑GLASS.
Depending on stiffness, mass, and damping, structures react differently to wind action.
- Which stresses are most important for glass design consideration when using RF-GLASS?
- I would like to design a glass pane with temperature loads. In this case, a message appears saying that the load case includes the "temperature" surface loads types that are not transferred to the created temporary model. How can I consider the temperature loads?
- Is it possible to design a spherically curved glass pane in RF‑GLASS?
- Are there any programs or add-on modules specially developed for glass structures?
- Which method of analysis is used for insulating glass?
- Is it possible to design insulating glass using the RF-GLASS add-on module?
- Does the activation of the partial safety factor GammaM have an effect on the calculation in RF‑GLASS?
- Is it possible to display the loads of the secondary seal of an insulating glass pane?
- When calculating a glass pane with RFEM, no stresses are displayed. Is there an error?
- Where can I find the details of a layer composition in the RF‑GLASS add-on module?