This article was translated by Google Translator View original text

When calculating a connection with the FRAMEmaker Pro add-on module, a message appears indicating that the value is outside the allowable range (Ret. Value: 108, min. Value 100, max. Value 100). What does the mentioned note mean?

Answer

The easiest way is to change to the design notes after the calculation or when the note appears in the design notes (see Figure 2). In this case, it is shown that the width of the end plate is not correct. When you change to input window 1.4.2, you quickly recognize in the graphic that it is not within the allowable range.

This can be corrected very quickly by adjusting the horizontal bolt spacings (see Figure 3).

Keywords

Note 35639 Design information Design Stop end plate

Downloads

Contact us

Contact Dlubal Software

Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.

(267) 702-2815

info-us@dlubal.com

RSTAB Connections
FRAME-JOINT Pro 8.xx

Add-on Module

Design of rigid bolted frame joints according to Eurocode 3 or DIN 18800

Price of First License
1,120.00 USD
RFEM Connections
RF-FRAME-JOINT Pro 5.xx

Add-on Module

Design of rigid bolted frame joints according to Eurocode 3 or DIN 18800

Price of First License
1,120.00 USD