Steel Column in Foundation
Model to Download
This model was used to demonstrate how to adjust the available steel bar diameters in RF-/FOUNDATION Pro.
Model Used in
- Views 118x
- Downloads 15x
- Updated 27 April 2021
The material model Orthotropic Masonry 2D is an elastoplastic model that additionally allows softening of the material, which can be different in the local x- and y-direction of a surface. The material model is suitable for (unreinforced) masonry walls with in-plane loads.
- Why do RF‑CONCRETE Members or CONCRETE determine a significantly higher provided reinforcement than the required reinforcement?
- SHAPE‑THIN calculates a very small shear area. Why?
- When calculating a connection using the FRAME‑JOINT Pro add-on module, a message appears saying that the value is out of the valid range (existing value: 108, minimum value 100, maximum value 100). What does this message mean?
- I have a trapezoidal roof structure that is supported by beams. However, the moments on the beams are smaller than they should be. What could be the reason for this?
- How can I calculate a timber-concrete composite floor with cross-laminated timber?
- Why are some load cases displayed in red in RF-STEEL EC3?
- Why does warning 155 appear as the result of the reinforced concrete design for members for the existing stirrup reinforcement?
- How can I model a thickened area of my concrete slab in RFEM such as a drop panel?
- Why are the equivalent member designs grayed out in the Stability tab when activating the plastic designs by using the partial internal force method (RF‑/STEEL Plasticity)?
For the deformation analysis by using RF‑CONCRETE Deflect, I have activated the consideration of creeping and shrinkage. Where can I see the creep coefficient and the coefficient of shrinkage applied for the calculation?