Chamfered Reinforced Concrete Flat Slab
Model to Download
Description
This model was used to demonstrate how to display additional information for line supports.
Model Used in
Keywords
Reinforced concrete flat slab Resulting line supports Support evaluation Result evaluation
Links
Write Comment...
Write Comment...
Disclaimer
You can download this structural analysis model to use it for training purposes or for your projects. However, we do not assume any guarantee or liability for the accuracy or completeness of the model.
New
Additional Information for Line Supports
For line supports, there is an option to graphically display the additional information for all directions.
- I have a roof structure resting on a steel column that runs to the foundations. The column runs through a perimeter wall that supports the false ceiling. A considerable part of the load from the roof is transferred to the wall. I want the steel column to carry all the vertical loads from the roof. How can I do it?
- Are the models and presentations from Info Day 2018 freely available, and can you send them to me?
- In RF‑CONCRETE Surfaces, I obtain a high amount of reinforcement in relation to a lever arm that is almost zero. How is such a small lever arm of internal forces created?
- What is the meaning of the superposition according to the CQC rule in a dynamic analysis??
- When converting from the manual definition of reinforcement areas to the automatic arrangement of reinforcement according to Window 1.4, the result of the deformation calculation differs, although the basic reinforcement has not been modified. What is the reason for this change?
- Does the program check the lap length of the vertical stirrups of a block foundation with smooth bucket sides?
- Why do I get a discontinuous area in the distribution of internal forces? In the area of the supported line, the shear force VEd shows a jump, which does not seems to be plausible.
- Is there a possibility in RFEM to define a global polar grid with the origin lies in the global zero point, for example, and which applies to several surfaces?
- When comparing RF‑CONCRETE Columns with another design software, I get different results. How to explain the differences?
- Is it possible to perform design without an additional reinforcement in RF‑CONCRETE Surfaces?
