It's time for innovation! Are you still working with RFEM 5 / RSTAB 8 or another structural analysis software and would you like to switch to the new generation of Dlubal programs? This two-part webinar is just right for you, because it makes it easier to get started with RFEM 6 / RSTAB 9.
In this webinar we show you how to use the structural analysis software RFEM for modeling beam and surface structures made of timber, entering loads, and combining load cases.
Webinars provide the opportunity to gain expert knowledge and to ensure you’re getting the most out of your Dlubal programs.
In this 65-minute webinar, we will show you how to use the structural analysis software RFEM to model beam and plate structures made of timber, enter the loads, and combine the loads.
In order to meet the needs of home users during the epidemic, and also help structural engineers and designers to further improve the software application level, we held a new phase of RFEM software online on March 11, 2020 at 15:00 Beijing time Video lecture, thank you for your active participation.
Topic in this issue: How to Perform Orthogonal Glulam CLT Analysis
content:
Add-on Module RF-LAMINATE-Introduction to Content and Calculation Process
Explanation of layer structure data input and calculation options
Reasonable modeling (eccentricity, line release, line hinge)
17:00 min: Load input (generation of member loads from area loads, generation of wind loads according to EC 1, determination of the wind zone on the Dlubal website)
32:00 min: Automatic generation of load and result combinations