FAQ 004158 EN
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
This article deals with rectilinear elements whose cross-section is subjected to axial compressive force. The purpose of this article is to show how quite a lot of parameters defined in the Eurocodes for concrete column calculation are considered in the RFEM structural analysis software.
The material model Orthotropic Masonry 2D is an elastoplastic model that additionally allows softening of the material, which can be different in the local x- and y-direction of a surface. The material model is suitable for (unreinforced) masonry walls with in-plane loads.
- In RF‑CONCRETE Surfaces, I obtain a high amount of reinforcement in relation to a lever arm that is almost zero. How is such a small lever arm of internal forces created?
- When converting from the manual definition of reinforcement areas to the automatic arrangement of reinforcement according to Window 1.4, the result of the deformation calculation differs, although the basic reinforcement has not been modified. What is the reason for this change?
- Why do I get a discontinuous area in the distribution of internal forces? In the area of the supported line, the shear force VEd shows a jump, which does not seems to be plausible.
- Is it possible to perform design without an additional reinforcement in RF‑CONCRETE Surfaces?
- I obtain different results when comparing the deformation analysis in the RF‑CONCRETE add-on modules and another calculation program. What could be the reason for this?
- For the design, I can only select the surrounding reinforcement for a rectangular cross-section. Why?
- What does the "Crack formation in the first 28 days" option means?
- I have recently purchased RSTAB with the CONCRETE add-on module. Can I use it to perform the stability analysis of reinforced concrete columns?
- Why do RF‑CONCRETE Members or CONCRETE determine a significantly higher provided reinforcement than the required reinforcement?
- Why do I get Error No. 10203 for a result beam when performing design with RF‑CONCRETE Members?
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements
Design of reinforced concrete members and surfaces (plates, walls, planar structures, shells)