Konstrukcja z profilu I jest osadzona w podporach widłowych. The axial rotation is restricted on both ends while warping is enabled. The structure is loaded by two transverse forces in the middle. The verification example is based on the example introduced by Gensichen and Lumpe.
Płaska kratownica składająca się z czterech nachylonych prętów i jednego pręta pionowego jest obciążona w górnym węźle siłą pionową i siłą skierowaną prostopadle do płaszczyzny. Assuming the large deformation analysis and neglecting the self-weight, determine the normal forces of the members and the out-of-plane displacement of the upper node.
Wybrano pręt w kształcie litery W zgodny z ASTM A992 tak, aby przeniósł ciężar własny 30 000 kN i obciążenie rozciągające 90 000 kN. Verify the member strength using both LRFD and ASD.
Rozważ belkę ASTM A992 W 18×50 dla stałych i równomiernych obciążeń stałych i ruchomych, jak pokazano na Rysunku 1. The member is limited to a maximum nominal depth of 18 inches. The live load deflection is limited to L/360. The beam is simply supported and continuously braced. Verify the available flexural strength of the selected beam, based on LRFD and ASD.
Zagęszczona sprężyna śrubowa jest obciążona siłą ściskającą. The spring has middle diameter D, wire diameter d, and it consists of i turns. The total length of the spring is L. Determine the total deflection of the spring for the member model and one‑turn deflection for the solid model.
Lekko nachylony pręt jest obciążony siłą skupioną, przytrzymywany przez sprężynę na jednym końcu i podparty na drugim końcu. Assuming large deformations and neglecting the member's self-weight, determine its maximum upward deflection.
Konstrukcja z profilu I jest w pełni utwierdzona na lewym końcu i osadzona w podporze przesuwnej na prawym końcu. The structure consists of two segments. The self-weight is neglected in this example. Determine the maximum deflection of the structure, the bending moment on the fixed end, the rotation of segment 2, and the reaction force at point B by means of the geometrically linear analysis and the second-order analysis. The verification example is based on the example introduced by Gensichen and Lumpe.
Cienkościenny wspornik profilu QRO jest w pełni zamocowany na lewym końcu, a deplanacja jest aktywna. The cantilever is subjected to torque. Small deformations are considered, and the self-weight is neglected. Determine the maximum rotation, primary moment, secondary moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Wspornik o profilu dwuteowym jest podparty na lewym końcu i obciążony momentem obrotowym. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).