Ramp and Trolley Girder
Model to Download
Description
Model Used in
Keywords
Write Comment...
Write Comment...
- Views 83x
- Downloads 6x
- Updated 07/12/2022
- Number of Nodes 21
- Number of Lines 21
- Number of Members 1
- Number of Surfaces 5
- Number of Solids 0
- Number of Load Cases 23
- Number of Load Combinations 0
- Number of Result Combinations 0
- Total Weight 13.053 t
- Dimensions 36,09 x 3,28 x 19,69 feet
Disclaimer

New
Consideration of Shear Stiffness for a Cross-Section Calculation in RFEM 6
This article shows you the internal forces and displacements of a continuous beam calculated both with and without consideration of shear stiffness.
-
How do I apply the ASCE 7 Orthogonal Directional Combination procedure (100% + 30% rule) to my seismic load in a static analysis?
- Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?
- Why the eHORA map of Austria gives different snow loads than your Geo-Zone tool?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
-
I would like to export nodal support forces of several load cases, load combinations and result combinations into an Excel spreadsheet in RFEM 6. How should I proceed?
- Where can find the option to hide the defined types (for example, design supports or effective lengths)?
- How do I create a user-defined Design Situation with my own chosen load combinations?
- How do I perform stability analysis to determine the critical load factor in RFEM 6?
- Is it possible in the CRANEWAY software to obtain the SLS rotational deformations of a continuous beam at the supports for an isostatic beam in the web plane?
- Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?