ASD Strength Design in RFEM 6
Answer
To run the design check according to ASD, you can create a copy of the existing ASD Design situation.
Under the selected Design Add-on - Design Situations tab, you can then set up the table to look like the following where the LRFD is disabled and the two ASD Design Situations are set to ASD limit state as well as Serviceability limit state.Keywords
ASD Design Situations Design Add-on
Write Comment...
Write Comment...
New
Distortional Buckling Design of Bottom Flange of Steel Frame Beam According to GB
New
Fire Resistance Design of Steel Components with Hot-Dip Galvanizing in RFEM 6 / RSTAB 9
New
AISI Cold-Formed Steel Design Using Custom Section in RFEM 6
New
Step by Step to Simulate Structural Collapse Using RFEM and Bullet Constraints Builder (BCB) in Blender
