Plate with interrupted support | Technical article 001663 from the Knowledge Base
Model to Download
Plate with interrupted support, which deals with the topic of ceiling beams or reinforced supporting strips.
Model Used in
- Views 312x
- Downloads 16x
- Updated 29 March 2021
In the case of using the slow‑curing concrete (usually for thick components), you can reduce the calculated minimum reinforcement by a factor of 0.85 to apply the load due to restraint, according to EN 1992‑1‑1, Section 7.3.2.
The material model Orthotropic Masonry 2D is an elastoplastic model that additionally allows softening of the material, which can be different in the local x- and y-direction of a surface. The material model is suitable for (unreinforced) masonry walls with in-plane loads.
- In connection with the analytical SLS calculation, I get implausibly large values for the crack width and deformation in the RF‑CONCRETE add-on modules. What is the cause and how can I fix the problem?
- Is it possible to export the results from RF‑CONCRETE Surfaces to Excel? For example, I would need the steel stress of serviceability design.
- Is it possible to adjust the initial values of the temperature courses entered for the fire resistance design? For example, I would like to adjust the initial value of the moisture content.
- How can I change the size of reinforcement bars from the American code (#3,#4, and so on) to millimeters in RF‑CONCRETE Members while using ACI?
- Is it possible in RF‑CONCRETE Surfaces to model a prefabricated slab or an element slab with different reinforcement layouts, for example, a reinforcement layer in a precast element and another reinforcement layer in the cast-in-place concrete extension?
- How do you perform the fatigue design for reinforced concrete and prestressed concrete? I have found a result combination of the type fatigue, but cannot find the design in the add-on modules.
Which units are specified in the result display of the support reactions (kN or kN/m)? A note about this is missing in the graphic.
In the case that the support reactions are given in kN/m, for which distance does the value apply?
Is it possible to specify shrinkage effects as loads?
- Where do I find the setting to specify the entered structural component as a "wall" or "slab"?
- The four plates, identically loaded, show different negative moments at the point of support. Is this a mistake?