Reinforced concrete slab
Model to Download
Description
Download the model of a reinforced concrete floor here and open it with the FEM program RFEM 6.
This model is used in the free online training "Introduction to Reinforced Concrete Design."
Model Used in
Keywords
Write Comment...
Write Comment...
Disclaimer

New
Consideration of Shear Stiffness for a Cross-Section Calculation in RFEM 6
This article shows you the internal forces and displacements of a continuous beam calculated both with and without consideration of shear stiffness.
-
Why the eHORA map of Austria gives different snow loads than your Geo-Zone tool?
- Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?
- How can I consider various wind profiles for various wind directions?
- Although all the member design checks have been fulfilled, I get the "Not Covered Reinforcement" result. What is the reason?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?