Question:
Why is it not possible to select the plate I want to cut/edit in the Plate Editor/Plate Cut?
Answer:
In RFEM 6, the order of the components plays an important role when editing joints; this sequence "runs" from top to bottom.
If you want to edit a plate, for example, you have to define the plate first in the list of components, and the Plate Editor component below it; the same principle also applies to other components, such as the Plate Cut.
Components that are related to other components must always be listed under the components to which they refer.
The video on the left shows you in detail how to proceed when modeling the connection without using the component library.