The structural analysis software RFEM 6 is the basis of a modular software system. The main program RFEM 6 is used to define structures, materials, and loads of planar and spatial structural systems consisting of plates, walls, shells, and members. The program also allows you to create combined structures as well as to model solid and contact elements.
RSTAB 9 is a powerful analysis and design software for 3D beam, frame, or truss structure calculations, reflecting the current state of the art and helping structural engineers meet requirements in modern civil engineering.
Do you often spend too long calculating cross-sections? Dlubal Software and the RSECTION stand-alone program facilitate your work by determining section properties of various cross-sections and performing a subsequent stress analysis.
Do you always know where the wind is blowing from? From the direction of innovation, of course! With RWIND 2, you have a program at your side that uses a digital wind tunnel for the numerical simulation of wind flows. The program simulates these flows around any building geometry and determines the wind loads on the surfaces.
Are you looking for an overview of snow load zones, wind zones, and seismic zones? Then you are in the right place. Use the Geo-Zone Tool to determine quickly and efficiently snow loads, wind speeds, and seismic data according to ASCE 7‑16 and other international standards.
Would you like to try out the capabilities of the Dlubal Software programs? You have the opportunity to do so! The free 90-day full version allows you to thoroughly test all our programs.
No, the add-in is not installed automatically.
This means you need to have Tekla Structures and RFEM 6 installed on your computer.
Afterwards, you have to navigate to the following folder:
This contains the "setup.exe" file. You can run it simply by double-clicking it. Tekla Add-in Installer appears.
After completing the setup, the add-in is installed and the corresponding function is available in the Tekla menu.
It is also necessary to ensure that the server has been started in RFEM. You can also find this setting in the RFEM menu "Options" under "Program Options".
Tekla Structures 2021-2024 are currently supported.
Tekla Structures 2023 can be used as of the version 6.02.0064.Tekla Structures 2024 can be used as of the version 6.06.0002.
This means that the user must have Revit and RFEM 6 installed on the computer. However, Revit should be closed in this case.
This contains the "setup.exe" file. You can run it simply by double-clicking it. The Revit Add-in Installer will open.
After completion, the add-in is installed and the corresponding function is available.
Currently, Revit 2021, 2022, 2023, and 2024 are supported.
Revit 2023 can be used as of the version 6.02.0049.Revit 2024 can be used as of the version 6.02.0068.