Przykład obliczeniowy opisuje obciążenia wiatrem działające na model grupy budynków w kilku kierunkach. The model consists of eight cubes. The velocity fields obtained by the RWIND simulation are compared with the measured values from the experiment. The experimental data are measured using a thermistor anemometer in the wind tunnel.
Przykład obliczeniowy opisuje obciążenia od ściskania ścian budynków w układzie tandem, zlokalizowanych w poziomie terenu. The buildings are simplified to rectangular objects and scaled down while maintaining the elevation ratios. The pressure distribution on the walls of the model of a medium-high building was conducted by an experiment. The chosen results (pressure coefficient Cp) are compared with the measured values.
Przykład obliczeniowy opisuje stacjonarny przepływ wokół wieżowca w postaci bloków miejskich (model w skali). The example is given by the Architectural Institute of Japan (AIJ). The chosen results (velocity magnitude) are compared with the measured values.
Przykład obliczeniowy opisuje stacjonarny przepływ wokół izolowanego budynku (model w skali). The chosen results (velocity magnitude) are compared with the measured values.
Pręt o zadanych warunkach brzegowych jest obciążony momentem skręcającym i siłą osiową. Neglecting its self-weight, determine the beam's maximum torsional deformation as well as its inner torsional moment, defined as the sum of a primary torsional moment and torsional moment caused by the normal force. Provide a comparison of those values while assuming or neglecting the influence of the normal force. The verification example is based on the example introduced by Gensichen and Lumpe.
Wspornik o profilu dwuteowym jest podparty na lewym końcu i obciążony momentem obrotowym. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).