Poniższy przykład obliczeniowy jest oparty na przykładzie obliczeniowym 0122. A single-mass system without damping is subjected to an axial loading force. An ideal elastic-plastic material with characteristics is assumed. Determine the time course of the end-point deflection, velocity, and acceleration.
Słup składa się z przekroju betonowego (prostokąt 100/200) oraz stalowego (profil I 200). It is subjected to pressure force. Determine the critical load and corresponding load factor. The theoretical solution is based on the buckling of a simple beam. In this case, two regions have to be taken into account due to different moments of inertia and material properties.
Przegubowa belka o przekroju prostokątnym jest poddana obciążeniu rozłożonemu i przesunięta w pionie za pomocą mimośrodu. Considering the small deformation theory, neglecting the self‑weight, and assuming that the beam is made of isotropic elastic material, determine the maximum deflection.
Ściana murowana jest poddana rozłożonemu obciążeniu w środku swojego górnego przekroju. The Isotropic Masonry 2D material model is compared with the Isotropic Linear Elastic model, with surface stiffness property Without Tension in the nonlinear calculation.
Cztery słupy są zamocowane na dole, a od góry połączone sztywnym blokiem. The block is loaded by pressure and modeled by an elastic material with a high modulus of elasticity. The outer columns are modeled by linear elastic material and the inner columns by a stress-strain diagram with decaying dependence. Assuming only the small deformation theory and neglecting the structure's self-weight, determine its maximum deflection.
Pionowy wspornik o kwadratowym przekroju jest obciążony u góry ciśnieniem rozciągającym. The cantilever consists of an isotropic material. Calculate the deflection.
Rozważmy połączenie rurowe rusztowania poddane działaniu siły osiowej i momentu. Self-weight is not considered. The material of the tube is idealized as perfectly rigid. All geometrical non-linearities are ignored. Determine the angle of deflection.
Określ maksymalne ugięcie bloku trójwymiarowego zamocowanego na obu końcach. The block is divided in the middle: the upper half is made of an elastic material and the lower part is made of timber - an elasto-plastic othotropic material with the yield surface described according to the Tsai-Wu plasticity theory. The block's middle plane is subjected to vertical pressure.
Należy określić maksymalne ugięcie czterech słupów zamocowanych u dołu i połączonych sztywnym blokiem u góry. The block is loaded by pressure and modeled by an elastic material with a high modulus of elasticity. The outer columns are modeled as orthotropic elastic material, and the inner columns as orthotropic elastic-plastic material with the same elastic parameters as the outer columns and plasticity properties defined according to the Tsai-Wu plasticity theory.
Należy określić maksymalne ugięcia bloku, uwzględniając lub pomijając efekt ścinania. The square block of the isotropic material is fully fixed at one end and loaded with uniform vertical pressure.