Rozważ belkę ASTM A992 W 18×50 dla stałych i równomiernych obciążeń stałych i ruchomych, jak pokazano na Rysunku 1. The member is limited to a maximum nominal depth of 18 inches. The live load deflection is limited to L/360. The beam is simply supported and continuously braced. Verify the available flexural strength of the selected beam, based on LRFD and ASD.
Cienka prostokątna płyta ortotropowa jest swobodnie podpierana i obciążona równomiernie rozłożonym ciśnieniem. The directions of axes x and y coincide with the principal directions. While neglecting self-weight, determine the maximum deflection of the plate.
Płyta eliptyczna z zakotwioną krawędzią nośną jest poddana równomiernie rozłożonemu obciążeniu poprzecznemu. Assuming the small deformation theory and neglecting the self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Na swobodnie podpartą płytę o przekroju trójkątnym równobocznym działa równomiernie rozłożone obciążenie poprzeczne. Assuming the small deformation theory and neglecting self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Przykład ten służy do zademonstrowania ograniczenia membrany. The application is shown on a two-story structure. The structure is loaded by means of lateral forces according to Figure 1. Determine the maximum deflection of the structure ux in the direction of the loading forces using both the diaphragm constraint and the plate model of the floor.
Płyta kompozytowa, składająca się z trzech warstw szkła, jednej warstwy folii i wewnętrznej przestrzeni z suchym powietrzem, jest w pełni utwierdzona i obciążona zmienną temperaturą. Neglecting its self-weight, determine the plate's maximum deflection.
Określ maksymalne ugięcie wspornika składającego się z dwóch warstw szkła i jednej warstwy folii pomiędzy nimi. The plate is fully fixed at one end and subjected to uniform pressure.
Wspornik o profilu dwuteowym jest podparty na lewym końcu i obciążony momentem obrotowym. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Jednowarstwowa kwadratowa płyta ortotropowa jest w pełni utwierdzona w punkcie środkowym i poddana działaniu ciśnienia. Compare the deflections of the plate corners to check the correctness of the transformation.
Szeroka płyta z otworem jest obciążona w jednym kierunku przez naprężenie rozciągające. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.