A thin rectangular orthotropic plate is simply supported and loaded by uniformly distributed pressure. The directions of axes x and y coincide with the principal directions. Maximální průhyb desky se stanoví bez zohlednění vlastní tíhy.
Eliptická deska se sevřeným ohraničením je vystavena rovnoměrně rozdělenému příčnému zatížení. Assuming the small deformation theory and neglecting the self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Jednoduše podepřená rovnostranná trojúhelníková deska je namáhána rovnoměrně rozděleným příčným zatížením. Assuming the small deformation theory and neglecting self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Tento příklad slouží jako ukázka vazby diafragma. The application is shown on a two-story structure. The structure is loaded by means of lateral forces according to Figure 1. Determine the maximum deflection of the structure ux in the direction of the loading forces using both the diaphragm constraint and the plate model of the floor.
Spřažená deska sestávající ze tří skleněných vrstev, jedné vrstvy fólie a vnitřního prostoru se suchým vzduchem je plně upevněna a zatížena proměnnou teplotou. Neglecting its self-weight, determine the plate's maximum deflection.
A timber beam reinforced by two steel plates at the ends is loaded by pressure. The wood fibers are parallel to the upper loaded side of the beam. Plastická plocha je popsána podle teorie plasticity Tsai-Wu.
Stanoví se maximální průhyb konzoly, která se skládá ze dvou skleněných vrstev a jedné vrstvy fólie mezi nimi. The plate is fully fixed at one end and subjected to uniform pressure.
Konzola s I-profilem je podepřena na levém konci a zatížena momentem. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Jednovrstvá čtvercová ortotropní deska je ve svém středu zcela fixována a namáhána tlakem. Compare the deflections of the plate corners to check the correctness of the transformation.
A timber beam reinforced by two steel plates at the ends is loaded by pressure. The wood fibers are parallel to the upper loaded side of the beam. Plastická plocha je popsána podle teorie plasticity Tsai-Wu.
Široká deska s otvorem je zatížena v jednom směru tahovým napětím. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.