Jednovrstvá čtvercová ortotropní deska je ve svém středu zcela fixována a namáhána tlakem. Compare the deflections of the plate corners to check the correctness of the transformation.
Na obou koncích je upevněn trojrozměrný blok z elasticko-plastického materiálu. The block's middle plane is subjected to a pressure load. The surface plasticity is described according to the Tsai-Wu plasticity theory.
Determine the maximum deflection of a three-dimensional block fixed at both ends. The block is divided in the middle: the upper half is made of an elastic material and the lower part is made of timber - an elasto-plastic othotropic material with the yield surface described according to the Tsai-Wu plasticity theory. Na rovinu procházející středem bloku působí svislý tlak.
Stanovíme maximální průhyb čtyř dolních sloupů spojených tuhým blokem nahoře. The block is loaded by pressure and modeled by an elastic material with a high modulus of elasticity. The outer columns are modeled as orthotropic elastic material, and the inner columns as orthotropic elastic-plastic material with the same elastic parameters as the outer columns and plasticity properties defined according to the Tsai-Wu plasticity theory.
A timber beam reinforced by two steel plates at the ends is loaded by pressure. The wood fibers are parallel to the upper loaded side of the beam. Plastická plocha je popsána podle teorie plasticity Tsai-Wu.
Na obou koncích je upevněn trojrozměrný blok z elasticko-plastického materiálu s vytvrzením. The block's middle plane is subjected to a pressure load. The surface plasticity is described according to the Tsai‑Wu plasticity theory.
Široká deska s otvorem je zatížena v jednom směru tahovým napětím. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.
A timber beam reinforced by two steel plates at the ends is loaded by pressure. The wood fibers are parallel to the upper loaded side of the beam. Plastická plocha je popsána podle teorie plasticity Tsai-Wu.
Ve spodní části jsou upevněny čtyři sloupy, které jsou nahoře spojeny tuhým blokem. The block is loaded by pressure and modeled by an elastic material with a high modulus of elasticity. The outer columns are modeled by linear elastic material and the inner columns by a stress-strain diagram with decaying dependence. Assuming only the small deformation theory and neglecting the structure's self-weight, determine its maximum deflection.
Stanoví se maximální průhyb konzoly, která se skládá ze dvou skleněných vrstev a jedné vrstvy fólie mezi nimi. The plate is fully fixed at one end and subjected to uniform pressure.