A column is composed of a concrete section (rectangle 100/200) and a steel section (profile I 200). Je vystaven tlakové síle. Determine the critical load and corresponding load factor. The theoretical solution is based on the buckling of a simple beam. In this case, two regions have to be taken into account due to different moments of inertia and material properties.
A quarter-circle beam with a rectangular cross-section is loaded by means of an out-of-plane force. This force causes a bending moment, torsional moment, and transverse force. Stanovíme celkový průhyb zakřiveného nosníku bez zohlednění vlastní tíhy.
Dvojhmotový systém se skládá ze dvou hřídelů a dvou hmot reprezentovaných příslušnými momenty setrvačnosti soustředěnými v dané vzdálenosti jako uzlové hmoty. The left shaft is fixed, and the right mass is free. Neglecting the self‑weight of the shafts, determine the torsional natural frequencies of the system.
Tento příklad slouží jako ukázka vazby diafragma. The application is shown on a two-story structure. The structure is loaded by means of lateral forces according to Figure 1. Determine the maximum deflection of the structure ux in the direction of the loading forces using both the diaphragm constraint and the plate model of the floor.
A member with the given boundary conditions is loaded by torsional moment and axial force. Neglecting its self-weight, determine the beam's maximum torsional deformation as well as its inner torsional moment, defined as the sum of a primary torsional moment and torsional moment caused by the normal force. Tyto hodnoty porovnáme při zohlednění nebo zanedbání vlivu normálové síly. The verification example is based on the example introduced by Gensichen and Lumpe.
Nosník je na levém konci zcela upevněn (deplanace je omezena) a na pravém konci je podepřen vidlicovou podporou (deplanace je povolena). The beam is subjected to a torque, longitudinal force, and transverse force. Determine the behavior of the primary torsional moment, secondary torsional moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Konzola s I-profilem je podepřena na levém konci a zatížena momentem. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).