Rovinný příhradový vazník, který se skládá ze čtyř šikmých prutů a jednoho svislého prutu, je zatížen v horním uzlu svislou silou a silou mimo rovinu. Assuming the large deformation analysis and neglecting the self-weight, determine the normal forces of the members and the out-of-plane displacement of the upper node.
A symmetrical shallow structure is made of eight equal truss members, which are embedded into hinge supports. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point when the snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. Vlastní tíha se v tomto příkladu nezohledňuje. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at the given deflections.
Prut s W-profilem podle ASTM A992 je vybrán tak, aby unesl vlastní tíhu 30 000 kips a užitné zatížení 90 000 kips v tahu. Verify the member strength using both LRFD and ASD.
A closely coiled helical spring is loaded by a compression force. The spring has middle diameter D, wire diameter d, and it consists of i turns. Celková délka pružiny je L. Determine the total deflection of the spring for the member model and one‑turn deflection for the solid model.
A truss structure consists of three rods (one steel and two copper) joined by a rigid member. The structure is loaded by a concentrated force and a temperature difference. Celkový průhyb konstrukce je stanoven bez zohlednění vlastní tíhy.
Prut s mírným sklonem je namáhán osamělou silou, na jednom konci je držen pružinou a na druhém konci podepřen. Assuming large deformations and neglecting the member's self-weight, determine its maximum upward deflection.
A member with the given boundary conditions is loaded by torsional moment and axial force. Neglecting its self-weight, determine the beam's maximum torsional deformation as well as its inner torsional moment, defined as the sum of a primary torsional moment and torsional moment caused by the normal force. Tyto hodnoty porovnáme při zohlednění nebo zanedbání vlivu normálové síly. The verification example is based on the example introduced by Gensichen and Lumpe.
Konzola s I-profilem je podepřena na levém konci a zatížena momentem. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).