Aluminium Facade | ADM
Model to Download
Description
Download the aluminium facade structure here and open it with the FEA software RFEM.
This model is used in the free webinar 'Member, Surface, and Solid Stress-Strain Analysis in RFEM 6' on 26 July, 2022 (English).
Model Used in
Keywords
Free webinar Member Surface Solid Stress Strain Nonlinear Plastic Von Mises
Write Comment...
Write Comment...
- Views 266x
- Downloads 13x
- Updated 30 November 2022
- Number of Nodes 20
- Number of Lines 24
- Number of Members 24
- Number of Surfaces 0
- Number of Solids 0
- Number of Load Cases 2
- Number of Load Combinations 3
- Number of Result Combinations 0
- Total Weight 0.355 t
- Dimensions 0.000 x 8.230 x 6.401 m
Disclaimer

New
Member Transverse Stiffeners in RFEM 6 and RSTAB 9
This article shows you how to define different types of member transverse stiffeners in RFEM 6 and RSTAB 9. It also shows you how to consider them in the design as well as the calculation of members with 7 degrees of freedom.

Aluminum Design | Tension Design Considering Reduced Cross-Sectional Area (such as Hole Weakening)
When connecting tension-loaded components with bolted connections, it is absolutely necessary to consider the cross-section reduction due to the bolt holes in the ultimate limit state design. The Aluminum Design add-on facilitates this procedure by entering a member local section reduction.
- My beam has a continuous lateral support and therefore lateral torsional buckling (LTB) is not a concern. How do I define the effective length?
- How do I consider the strength of weld-affected zone for aluminum?
- How can I carry out case-related design for different load situations?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
- How do I create a user-defined Design Situation with my own chosen load combinations?
- Where can I find the materials for the corresponding National Annexes in RFEM 6 and RSTAB 9?
- How do I apply load on members that are non coplanar in RFEM 6?
- How do I apply wind load on members of open structures?
- I encountered a sharing violation while importing a dxf file into SHAPE‑THIN. What is the issue?