This project deals with structural evaluation against climatic loads and the utilization and seismic analysis of an existing telecommunications tower performed by SAQQARA INGENIERIA S.L., a customer of Dlubal Software. The structure is a lattice tower with a square section plan, made of steel cross-sections, with a radar and the necessary auxiliary equipment installed on it, including a spherical radome as a mimicry.
In Cologne, a new exhibition greenhouse and an orangery are going to enrich the Flora botanical garden. The exhibition greenhouse consists of three arched building sections that are connected to each other.
The goal was to design a spiral staircase with glass steps and railings spanning 2 floors. With sophisticated anchoring details and helical stringers created from subtle rectangular hollow sections, a light and elegant staircase was formed. The interior spiral staircase is located inside the educational, training, and rehabilitation center in the city of Zlín.
The station building is an organic shaped steel structure consisting of three connected parts. The left and right building sections are formed by curved Vierendeel truss beams extruding from the main Vierendeel truss down to the reinforced concrete foundation. These main trusses are supported by a row of columns with additional vertical bracing.
On the Mediterranean island of Formentera, a new cross-laminated timber building was constructed, which is used by a sailing school and a water sports center. The one-story building consists of two separate sections that are connected by low-lying glued-laminated beams in the roof area.
A kindergarten, designed according to Building Information Modeling (BIM), is currently under construction in the Tyrolean municipality of Schwoich. The digital 3D model accompanies the construction project from design until completion.
The architectural planning was performed with Autodesk Revit. The structural model, including cross-sections, materials, loads, and so on, was exported to RFEM with the direct interface and designed there.
The designed object is a heat exchanger to which a chimney was set up, a construction with an overall height of 199.1 ft. The structure consists mainly of sheets that were reinforced by exterior steel cross-sections in the bottom area.
The tripper car bridge is a part of the conveyor belt structure realized in Uzbekistan.
The engineering office of Jürgen Ehlenz, a customer of Dlubal Software, was responsible for the structural analysis and detailed design of the conveyor bridge and other parts of the conveyor belt system.