Calculation with American Steel Cross-Sections
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
SHAPE-THIN determines the effective cross-sections according to EN 1993-1-3 and EN 1993-1-5 for cold-formed sections. You can optionally check the geometric conditions for the applicability of the standard specified in EN 1993‑1‑3, Section 5.2.
The effects of local plate buckling are considered according to the method of reduced widths and the possible buckling of stiffeners (instability) is considered for stiffened sections according to EN 1993-1-3, Section 5.5.
As an option, you can perform an iterative calculation to optimize the effective cross-section.
You can display the effective cross-sections graphically.
Read more about designing cold-formed sections with SHAPE-THIN and RF-/STEEL Cold-Formed Sections in this technical article: Design of a Thin-Walled, Cold-Formed C-Section According to EN 1993-1-3.
- Can RF-STEEL AISC optimize cross-sections for Serviceabillity?
- After running the design in RF-STEEL AISC, I receive error message 1002 - Invalid cross-section of type "Channel" according to F2. What does this error mean?
- Does RF-STEEL AISC perform torsion design per Design Guide No. 9?
- RF-STEEL AISC add-module shows non-designable results for general cross-sections because of shear buckling checks according to Chapter G. How do I solve this?
What are the options in RFEM or RSTAB for determining the ideal elastic critical moment for any cross-sections and systems/loads?
Is it also possible to design flat steel (brackets, flat steel stringers of staircases)?
- When calculating a connection with the FRAME JOINT Pro add -on module, a message appears saying that the value is outside the allowable range (prev. Value: 108, min. Value 100, max. Value 100). What does this message mean?
- I have a trapezoidal roof structure that is supported by beams. However, the moments on the beams are smaller than they should be. What could be the reason for this?
- Why are some load cases displayed in red in RF-STEEL EC3?
- Why are the equivalent member designs grayed out in the Stability tab when activating the plastic designs by using the partial internal force method (RF‑/STEEL Plasticity)?
- At which position are the determined support forces for the crane runway girder? At the bottom flange of the crane runway girder or in the shear center of the cross -section?
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements
The structural engineering software for design of frame, beam and truss structures, performing linear and nonlinear calculations of internal forces, deformations, and support reactions