4087x
002528
2021-04-30

Internal Forces at Certain Nodes in Printout Report

Where can I find the internal forces at certain nodes in the printout report?


Answer:

The easiest way to find the internal forces at these nodes is to print the graphics of the members in the printout report.

If this solution is not possible, you can also find the values in results table 4.1 in the printout report. Since the extreme values are only activated by default, it is still necessary to activate the nodal values in the selection.

It is usually not reasonable to include the internal forces of all members in the printout report. Therefore, you can only select the members that are relevant to you.