The structural analysis software RFEM 6 is the basis of a modular software system. The main program RFEM 6 is used to define structures, materials, and loads of planar and spatial structural systems consisting of plates, walls, shells, and members. The program also allows you to create combined structures as well as to model solid and contact elements.
RSTAB 9 is a powerful analysis and design software for 3D beam, frame, or truss structure calculations, reflecting the current state of the art and helping structural engineers meet requirements in modern civil engineering.
Do you often spend too long calculating cross-sections? Dlubal Software and the RSECTION stand-alone program facilitate your work by determining section properties of various cross-sections and performing a subsequent stress analysis.
Do you always know where the wind is blowing from? From the direction of innovation, of course! With RWIND 2, you have a program at your side that uses a digital wind tunnel for the numerical simulation of wind flows. The program simulates these flows around any building geometry and determines the wind loads on the surfaces.
Are you looking for an overview of snow load zones, wind zones, and seismic zones? Then you are in the right place. Use the Geo-Zone Tool to determine quickly and efficiently snow loads, wind speeds, and seismic data according to ASCE 7‑16 and other international standards.
Would you like to try out the capabilities of the Dlubal Software programs? You have the opportunity to do so! The free 90-day full version allows you to thoroughly test all our programs.
The ASCE 7-22 standard provides several types of design spectra. In this FAQ, we would like to focus on the following two design spectra:
The two-period spectrum is implemented in the program as usual. However, based on the data available from the standard, only the horizontal design spectrum / MCER spectrum as well as the modification related to the force and displacement can be offered.
For the multi-period design spectrum, discrete numerical values are specified. ASCE 7‑22 states that these values can be queried on the USGS Seismic Design Geodatabase page. In the current state of development, you have the option to create a user-defined response spectrum with a g‑factor (depending on the mass conversion constant) to use the data from the ASCE 7 Hazard Tool [1], for example.
Please proceed as follows:
Only some fictitious blank pages are inserted and added to the table of contents. Thus, the printout report can be printed out on paper and then supplemented with your own documents from other programs (Excel tables, Word documents, or drawings). The table of contents and the page numbering are adjusted automatically.
In order to remove the blank rows in the table (Image 01) and avoid deleting every single row, it would be reasonable to use the "Renumber" tool: