19x
005030
0001-01-01

5.1.3.3 Clipper

Clipper

Sections through the model can be created by means of a Slicer or a Clipper. Select one of the Clipper options available in the Clipper Settings section of the panel to activate it. With the Clipper - Plane option, the results of the zone behind (or in front of) the cutting plane are displayed. Alternatively, you can apply a Clipper - Box to examine the results on the surfaces of a box-shaped cutout.

The clipper options are only suitable for 3D finite volume mesh output, such as pressure field or velocity field results.

Note

Image 5.29 Results in Clipper - Plane display

The settings options of the Clipper tab correspond to those of the Slicer. You can modify the clipper plane graphically via one of the four bullets shown in the corners of the section plane. When you pull the clipper plane along a wind tunnel line, the results are updated dynamically.

Parent Chapter