483x
001579
2020-07-16

FAQ 004525 | I am trying to verify RF‑CONCRETE Surfaces based on the results of the example...

Question:
I am trying to verify RF‑CONCRETE Surfaces based on the results of the example in the manual. Chapter 2.4.3 describes the determination of the statically required reinforcement. Unfortunately, I cannot create an example that exactly represents these results. Can you send me the corresponding example?

Answer:
You can download the corresponding example under the link below.

The results shown in Figure 2.39 in the manual of RF‑CONCRETE Surfaces come from the reinforcement in the bottom position in Grid Point R27 - see the following image with the design details for this point.