Stworzenie przykładu walidacyjnego dla obliczeniowej mechaniki płynów (CFD) jest kluczowym krokiem w zapewnieniu dokładności i wiarygodności wyników symulacji. This process involves comparing the outcomes of CFD simulations with experimental or analytical data from real-world scenarios. The objective is to establish that the CFD model can faithfully replicate the physical phenomena it is intended to simulate.
Obliczenia konstrukcji złożonych za pomocą oprogramowania do analizy elementów skończonych są zazwyczaj przeprowadzane na całym modelu. Jednak wznoszenie tego typu konstrukcji jest procesem wieloetapowym, w którym ostateczny stan konstrukcji uzyskuje się poprzez połączenie poszczególnych elementów konstrukcyjnych. Aby uniknąć błędów w obliczeniach ogólnych modeli, należy wziąć pod uwagę wpływ procesu konstrukcyjnego. W programie RFEM 6 jest to możliwe za pomocą rozszerzenia Analiza etapów budowy (CSA).
Bei der Glasbemessung im Zusatzmodul RF-GLAS stehen grundsätzlich zwei verschiedene Berechnungsoptionen zur Verfügung: eine 2D- und eine 3D-Berechnung. Grundsätzlicher Unterschied dieser beiden Bemessungsvarianten ist die vom Programm automatisierte Modellierung der Scheiben im temporären Modell. Bei einer 2D-Bemessung werden für die einzelnen Scheiben gängige Flächenelemente (Plattentheorie) generiert, während bei der 3D-Bemessung die einzelnen Scheiben als Volumen abgebildet werden. Je nach gewähltem Schichtaufbau steht die Option zur Wahl oder wird vom Programm bereits automatisch vorgegeben.
In RFEM und RSTAB können Modellobjekte in der Grafik mit einem Kommentar versehen werden. Beim Einfügen eines Kommentars springt der Ursprung der aktuellen Arbeitsebene automatisch temporär in dieselbe Ebene, in der der Kommentar gesetzt wird. Dadurch wird verhindert, dass Kommentare versehentlich sehr weit vom Objekt abgelegt werden.
Projektowanie sztywnych połączeń z blachami czołowymi jest szczególnie skomplikowane w przypadku geometrii połączeń gdzie występują cztery łączniki w jednym rzędzie oraz dwukierunkowe zginanie, ponieważ nie istnieją oficjalne wytyczne do wymiarowania tego typu detali.
W celu analizy wyników na powierzchniach w programie RFEM istnieje możliwość definiowania przekrojów. Hierbei stehen grundsätzlich zwei verschiedene Arten von Schnitten zur Verfügung. Einerseits, das Anlegen eines temporären Schnittes, welcher nur einmalig die Ergebnisverläufe der gewünschten Schnittkante anzeigt und anderseits die Definition eines Schnittes im Dialog, welcher dann als eigenes Objekt in RFEM angelegt wird und somit die Ergebnisse jederzeit betrachtet werden können. Die Ergebnisdarstellung von definierten Schnitten erfolgt graphisch in RFEM, kann aber auch separat als Dialog angezeigt und mit in das Ausdruckprotokoll übernommen werden.
Lokalny układ współrzędnych pręta jest szczególnie istotny podczas definiowania zwolnień na końcach pręta i nieliniowości prętów. Je nach Ausrichtung der Achsen werden anschließend die Definitionen vorgenommen. Die Sichtbarkeit dieser Stabachsen kann temporär mittels der Vorselektion gesteuert werden.