This input window appears only if an analysis according to EN 1995-1-1 [2] or DIN 1052 [2] has been set in module window 1.1 General Data. You define the load duration of the loads in order to determine the climatic conditions for the limit checks.
The table column lists all actions that have been selected for the limit checks in module window 1.1 General Data. In case of combinations, included load cases are also displayed.
The load case descriptions make the classification easier.
This table column shows the action types of the load cases as they were defined in RFEM or RSTAB during their creation. They form the basis for the settings in the next table column.
The limit checks require the assignment of loads and their superpositions to particular load duration classes.
For load cases you can change the load duration with the list shown on the left:
Click into a table cell in column C.
The 
button will be enabled.
In case of unambiguous load and result combinations, RF-/LIMITS carries out the classification automatically taking intoaccount the respective governing action.
The load duration class LDC is required for the determination of the modification factor kmod. The factor is also considered for the material stiffness.
If an automatic combination of the actions was set in RFEM or RSTAB, the load duration classes are automatically taken into account according to the specifications in RFEM or RSTAB. Thus, a redefinition in RF-/LIMITS is not necessary. However, it is possible to adjust this classification by selecting another setting.