Results of Punching | Concrete design in RFEM 6
Contact Us
Unable to find the answer to your question? Contact us via phone, email, chat or forum or send us your question directly through our online form.
Submit Individual Question
Punching Shear Design in RFEM 6
The punching shear design, in line with EN 1992-1-1, should be performed for slabs with a concentrated load or reaction. The node where the design of punching shear resistance is performed (i.e., where there is a punching problem) is called a node of punching shear. The concentrated load at these nodes can be introduced by columns, concentrated force, or nodal supports. The end of the linear load introduction on slabs is also regarded as a concentrated load and therefore, the shear resistance at wall ends, wall corners, and ends or corners of line loads and line supports should be controlled as well.
-
The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?
- How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
- Is it possible to display the reinforcement description in RFEM 6?
- I would like to export nodal support forces of several load cases, load combinations and result combinations into an Excel spreadsheet in RFEM 6. How should I proceed?
- Where can find the option to hide the defined types (for example, design supports or effective lengths)?
- How do I create a user-defined Design Situation with my own chosen load combinations?
- Can I define a different bar size in the RFEM 6 Concrete Design add-on other than the default bar sizes available in the drop-down?
- Can the RFEM 6 Concrete Design add-on automatically design member and surface reinforcement?
- Is it possible to define only the user-defined additional reinforcement in certain areas of a surface in RF‑CONCRETE Surfaces, while the rest is determined automatically?
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?