46 Results
View Results:
Sort by:
Question
How do I determine the stiffness center of my structural system?
Question
Why do the results of members and sets of members differ in the design?
Question
How can I create a curved or arched section?
Question
I am designing a cross-section created in the SHAPE‑THIN program using the design add-on module, but the program shows the error message "ER006 Invalid type of c/t-part for cross-section of type General". What can I do?
Question
I would like to calculate a hall frame with loads from a crane runway. It is not quite clear to me what the various action categories denote. Can you explain it to me?
Question
How can I determine loads at particular geographic coordinates in the online service "Snow Load, Wind Speed, and Seismic Load Maps"?
Question
How are the location-specific Geo-Zone Tool data queries calculated for the determination of various building loads?
Question
Is it possible to generate wind loads according to DIN EN 13782 with this program?
Question
Why is the load value displayed in the online service "Geo-Zone Tool: Snow Load, Wind Speed, and Seismic Load Maps" different from the value in the corresponding standard in some cases?
Exclude Lateral Torsional Buckling Check
My beam has a continuous lateral support and therefore lateral torsional buckling (LTB) is not a concern. How do I define the effective length?
Imperfection from Mode Shape
How do I create an imperfection based on a mode shape in RFEM 6?
Question
I need to define different types of lateral intermediate restrains for a single element in RF-/STEEL EC3. Is this possible?
Question
Is it possible to perform design for a timber-concrete composite cross-section?
Question
For the foundation design, I need the results (support reactions) of the design situation for "static equilibrium". How do I get them?
AISI Table B4.1-1 Applicability Limits
Does RFEM check the applicability limits of AISI Table B4.1‑1?
Standardized Sections for AISI Design
Which standardized sections are valid for AISI cold-formed steel design in RFEM 6?
Question
How can I create a drilled beam in RFEM?
Question
Which result combinations can I design with the RF‑/JOINTS Pro program, and what should I pay attention to?
Question
Is it also possible to integrate the online service "Snow Load, Wind Speed, and Seismic Load Maps" into external applications?
- 005113
- Timber Design for RFEM 6
- Timber Design for RSTAB 9
-
- Aluminum Design for RFEM 6
- Aluminum Design for RSTAB 9
- Steel Design for RFEM 6
- Steel Design for RSTAB 9
- Stress-Strain Analysis for RFEM 6
- Stress-Strain Analysis for RSTAB 9
- Steel Joints for RFEM 6
- Timber Structures
- Concrete Structures
- Steel Structures
- Structural Analysis & Design
- Eurocode 2
- Eurocode 3
- Eurocode 5
- Eurocode 9